Hi Patrice,
I am not sure, but I assume this behaviour is controled by "Auto-save design changes" user preference setting. If it's switched off, MicroStation waits for a confirmation if changes should be saved or not.
What is correct / expected MicroStation behaviour in your scenario, wheather there are unsaved design file modifications? To close the file without saving or to save all changes automatically?
With regards,
Jan
I am not sure, but I assume this behaviour is controled by "Auto-save design changes" user preference setting. If it's switched off, MicroStation waits for a confirmation if changes should be saved or not.
What is correct / expected MicroStation behaviour in your scenario, wheather there are unsaved design file modifications? To close the file without saving or to save all changes automatically?
With regards,
Jan